Home
  Search Archives     
  Available Archives
   1969-1979
   1980-1989
   1990-1999
   2000-2009
   2010-2017
    1969    
    1969    
1970
1970
1970
1971
1971
1971
1972
1972
1972
1973
1973
1973
1974
1974
1974
1975
1975
1975
1976
1976
1976
1977
1977
1977
1978
1978
1978
1979
1979
1979
    1980    
    1980    
1981
1981
1981
1982
1982
1982
1983
1983
1983
1984
1984
1984
1985
1985
1985
1986
1986
1986
1987
1987
1987
1988
1988
1988
1989
1989
1989
    1990    
    1990    
1991
1991
1991
1992
1992
1992
1993
1993
1993
1994
1994
1994
1995
1995
1995
1996
1996
1996
1997
1997
1997
1998
1998
1998
1999
1999
1999
    2000    
    2000    
2001
2001
2001
2002
2002
2002
2003
2003
2003
2004
2004
2004
2005
2005
2005
2006
2006
2006
2007
2007
2007
2008
2008
2008
2009
2009
2009
    2010    
    2010    
2011
2011
2011
2012
2012
2012
2013
2013
2013
2014
2014
2014
2015
2015
2015
2016
2016
2016
2017
2017
2017

 
   1995 >> October >> Block News  

Block News
by Tim Baggett

Reprinted from "Crown Jewels of the Wire", October 1995, page 14

The photos on the following page show two porcelain block insulators purchased in the Middle Tennessee area.

The insulator on the left is similar to a CD 1002 and is cobalt blue in color. Gary Short of Chapmansboro, Tennessee purchased it in an antique shop in Portland, Tennessee last January along with several other pintype insulators.

The insulator on the right is basically the same only a little bit smaller. The color is dark and light gray with some splashes of red in the glaze. It was purchased at an antique store in Guthrie, Kentucky on the Tennessee state line. I purchased this insulator a little over a year ago.

Supposedly, the block I purchased came from the Gallatin, Tennessee area. If the insulator on the left is a local find, these insulators could be from the line which ran from Louisville, Kentucky to New Orleans. These could possibly have been used along with the glass blocks which were found in Gallatin years ago.

The insulator on the left has been cracked in half and repaired, but there is no material missing. It also still has oxidation stains on each end indicating that it has been in use. The bottom of the wire groove on this insulator is rough with a gritty finish to the glaze to prevent line wire slippage. The insulator on the right has a smooth wire groove.

Any additional information on these blocks that you readers might share with me would me most appreciated.

TIM BAGGETT, 3030 E. Old Ashland City Rd.,
Clarksville, TN 37043-5506 (615) 645-5845



| Magazine Home | Search the Archives |